How to use anti drone PD1
- 2023-09-26
- 265
- Clairvoyant Aviation Technologies INC.(NANJING,CHINA)
PD1 multi-band directional drone signal jammer shield ,The multi-frequency and multi-standard directional locking is used to suppress and block radio waves, and the ultra-high speed sweep frequency technology is used to generate a variety of broadband signals to strike the UAV.It has small size, light weight,good mobility,Passive no radiation, interference does not affect the user's own electromagnetic equipment and other advantages . The device supports GPS positioning, which can be used for real-time monitoring of this series of interceptor devices through the background, and can be used in networking with low altitude radar system, spectrum detection system, photoelectric exploration detection system, video tracking and identification system. When low, small and slow aircraft enter the prevention and control area, it can lose the picture transmission signal and control signal, and the GPS link can effectively suppress the remote,so lt can force landing and driving away of unlicensed flying drones without approval.
Operating instruction
1. Place the support horizontally on the flat ground. A level is provided in the direction indicated in Figure 1 for reference,Use Figure 6 to adjust to the proper height and tighten it;
2. Place the jamming shield body card put in the clip slot in FIG. 10 and tighten the clip lock in FIG. 5;
3. Connect one end of the cable in Figure 9 to the power box and the other end to the interference shield device, and tighten the nuts on the two ends.
4. Turn on the power switch and turn on the button switch of the required frequency band based on the required function.
5. Hold the handle in Figure 4 with the right hand and the left handle of the UAV body with the left hand to control the direction of the jamming shield for mission strike and intercept;
6. After the task is complete, turn off the switches in each frequency band of the jamming shield and then turn off the power switch. Finally unplug the power cord.